The Epson 288 ink cartridge can be refilled, however there are a few considerations. This article will show you How To Refill 288 ink Cartridge and reset the ink level, as well as the steps necessary to make your cartridge refill compatible.
A feature of the Epson printer allows ink cartridges to be refilled. With the large refillable ink cartridges included in these Epson printer models, you may print hundreds or even thousands of pages before having to replace the ink cartridge. Instead, you simply need to replenish the ink you frequently need for daily necessities. If you frequently use yellow, for instance, you simply need to reorder yellow ink.
Instructions for refilling an Epson ink cartridge
The Epson 288 ink Refill are reasonably priced and economical. It is inexpensive since the four ink bottles cost 50% less than the typical cost of the tri-color and black inkjet cartridges. Because you can print tens of thousands of pages before running out of ink, it is economical. The enjoyable part is finally here. However, make sure you have the necessary supplies before you begin refilling your cartridge: Jar of distilled water (NOT mineral water), Gloves, Old newspapers, 3 mm drill, L-shaped plugs
First, remove a small piece of plastic from one of your syringes’ tips and set it aside; you’ll need it later.
Next, find the circular indent on your cartridge label that is situated between the model number and the colour. You should drill the hole here so that you may insert the ink. To remove any debris from the cartridge and prevent it from falling back into the hole, use your drill. Put distilled water in the opening and plug it up.
Every time you contact the distilled water jar, use a fresh set of syringes and needles. If you don’t have enough, clean them by washing the ones you do have in warm water. Use the specific cut syringe to drain the liquid out of the cartridge and remove the water-old ink-debris mixture.
When you take the plug out of the cartridge hole, pay attention to the sound it makes. Instead of making a noise like a cork being pulled from a bottle, it should be silent. If you hear a “popping” sound upon removing the cork, the air channel is probably broken and has caused a vacuum inside the cartridge.
The next step is quite simple: fill the cartridge with ink using one of your syringes. You’ll need to utilise roughly 8 millilitres of ink for the 288 cartridges. One tip is to try inserting your needle through the cartridge’s second layer. You may be able to fill up to 10 millilitres with ink depending on how far you can push your needle. At blogtrib you can find troubleshooting of How To Refill 288 ink Cartridge.
You can now use any type of ink, including dye, pigment, and sublimation ink, because you’ve flushed the cartridge. To confirm that your ink is working properly, re-install the cartridge into the printer and perform a print test. If the check results are subpar, you can clean the nozzle using the printer’s built-in cleaning feature.